Hi, I'm using linuxsampler without a GUI talking directly to the server trough port 8888. Until now I can add devices, setup channels, load samples, assign midi channels too, everything plays beautiful but I can't make effects to work.
So I created an FX send on the channel:
CREATE FX_SEND 0 0 'fxname'
Then:
CREATE EFFECT_INSTANCE 43
ADD SEND_EFFECT_CHAIN 0
APPEND SEND_EFFECT_CHAIN EFFECT 0 0 0
I get OK with no errors but there's no differences on the sound, tried to modify send value with:
SET FX_SEND LEVEL 0 0 1
Also did
SET FX_SEND EFFECT 0 0 0 0 but nothing
Also modified parameters on the effect with SET EFFECT_INSTANCE_INPUT_CONTROL VALUE
and nothing changed..
I just want a list of commands in order, so I can get effects working, lets say at Device 0, Midi 16, Linuxsampler Channel 0, Effect Index 43
Thank you in advance!!
Linuxsampler and Internal FX
Re: Linuxsampler and Internal FX
That's probably because you just created FX send channels so far. You need however also to load some effect.
When the sampler is launched, make sure you see this:
Because right now the sampler will only load LADSPA effect plugins yet.
Then check what kind of LADSPA effects the sampler found and are available with
and
Then create the effect with
and finally route the respective FX send channels to the respective effect.
See also http://www.linuxsampler.org/api/draft-linuxsampler-protocol.html#effects
When the sampler is launched, make sure you see this:
Code: Select all
Registered internal effect systems: LADSPA
Then check what kind of LADSPA effects the sampler found and are available with
Code: Select all
LIST AVAILABLE_EFFECTS
Code: Select all
GET EFFECT INFO <id>
Code: Select all
CREATE EFFECT_INSTANCE
See also http://www.linuxsampler.org/api/draft-linuxsampler-protocol.html#effects