bb.linuxsampler.org

LinuxSampler occasionally makes unwanted bass sounds, that do not correspond to the MIDI notes or instructions that Ardour 3 sends to it (via the LV2 instrument plugin). Have others experienced this? Is there techniques to prevent it from happening.

I have five MIDI tracks in Ardour:
1. cowbell
2. cymbals
3. snare, handcaps, and toms
4. Bass Drum
5. Bass guitar

In LinuxSampler (Fantasia) I have 5 channels each with FluidR3_GM.sf2 loaded. The four percussion channels are on channel 10. Bass guitar is on channel 1. I am running Ubuntu Studio 10.04 with 4 GB RAM, low-latency kernel.

If I play from start to finish I usually hear two or three unwanted bass sounds, but if I stop playback and replay the trouble section, the bass sound is not there.

David,

I am not experienced, but

I use for each instrument a separate channel

If this is not the problem, I should check my samples in a wave editor.

Are the regions correct?

By the way, thanks for your advice how to compile linuxsamplerr. It is very usefull.

kind regards,

JanFlorijn

David,

Do you have in Ardour other instruments wich sents midi messages to linuxsampler and to wich is not a assigned a instrument?

Kind regards,


JanFlorijn