Hi all,
I succeeded tot compile Linuxsampler and the libs and tools for 32-bit.
There is one problem:
After installing this snd vir-midi does not work.
asjmidid -e does work.
Linuxsampler starts but I can not connect virtually midi ports in jack simply because they do not exist.
This is an totally new fact.
I have installed the nessecary libs for jack and libasound.
It does not work.
Whoe has an idea?
Kind regards,
JanFlorijn
Vir-midi does not work after compiling and installing LS
-
- User
- Posts: 61
- Joined: Fri Jan 03, 2014 5:59 pm
Re: Vir-midi does not work after compiling and installing LS
On my system, AVLinux 6.0.3, virmidi must be started by loading the virmidi kernel module with command: sudo modprobe snd-virmidi However, its possible to have this module loaded automatically at start up. You can check if this module is running with command:
$ lsmod | grep virmidi
snd_virmidi 1911 0
...
(you should see that snd_virmidi kernel module is running)
$ lsmod | grep virmidi
snd_virmidi 1911 0
...
(you should see that snd_virmidi kernel module is running)
-
- User
- Posts: 61
- Joined: Fri Jan 03, 2014 5:59 pm
Re: Vir-midi does not work after compiling and installing LS
Hi,
I suppose you type: a2jmidid -e and you run 'linuxsampler'
I use in Linux qjackctl. In qjackctl I connect the alsa midi ports of my sequenser with the ports of a2j.
Kind regards,
JanFlorijn
I suppose you type: a2jmidid -e and you run 'linuxsampler'
I use in Linux qjackctl. In qjackctl I connect the alsa midi ports of my sequenser with the ports of a2j.
Kind regards,
JanFlorijn